caa a22 4500 465741762 CHVBK 20180323111810.0 cr unu---uuuuu 170327e19901201xx s 000 0 eng 10.1007/BF00037155 doi (NATIONALLICENCE)springer-10.1007/BF00037155 Chai Herzl Polymers Division, Institute for Materials Science and Engineering, National Institute of Standards and Technology, 20899, Gaithersburg, Maryland, USA aut Three-dimensional fracture analysis of thin-film debonding [Elektronische Daten] [Herzl Chai] A simplified mixed-mode fracture analysis combining nonlinear thin-plate stress solutions with crack-tip elasticity results has been developed to account for local variations of G I, G II and G III in thin-film debond problems associated with large film deformations. Membrane and bending stresses from the plate analysis are matched with the crack-tip singularity solution over a small boundary region at the crack tip where the effect of geometric nonlinearity is small. Local variations in each of the individual components of the energy release rate are directly related to the "jump” in these stresses across the crack border. Specific results are presented for 1-D and elliptical planeform cracks. Deformations were induced either by a pressure acting normal to the film surface or biaxial compression or tension stresses applied to the substrate in which the loading axes and debond axes coincide. The latter type of loading involves buckling of the delaminated film. The model predictions compare well with more rigorous solutions provided the film thickness is small compared to the debond dimensions. In all cases analyzed, G III was negligible. The ratio G I/G II typically decreases with increasing load or film deformation, the rate was moderate for pressure loading while generally sharp for compression loading. Film-substrate overlap may occur for certain debond geometry and loading conditions. Prevention of this by the substrate may critically increase the energy available for crack propagation. Kluwer Academic Publishers, 1990 International Journal of Fracture Kluwer Academic Publishers 46/4(1990-12-01), 237-256 0376-9429 46:4<237 1990 46 10704 https://doi.org/10.1007/BF00037155 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/BF00037155 text/html Onlinezugriff via DOI NATIONALLICENCE 100 1- Chai Herzl Polymers Division, Institute for Materials Science and Engineering, National Institute of Standards and Technology, 20899, Gaithersburg, Maryland, USA aut NATIONALLICENCE 773 0- International Journal of Fracture Kluwer Academic Publishers 46/4(1990-12-01), 237-256 0376-9429 46:4<237 1990 46 10704 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer