caa a22 4500 46798137X CHVBK 20180323112519.0 cr unu---uuuuu 170328e19900901xx s 000 0 eng 10.1007/BF00693342 doi (NATIONALLICENCE)springer-10.1007/BF00693342 Gromyko A. aut Influence of casting method of plain bearings on the structure of babbitts [Elektronische Daten] [A. Gromyko] Conclusions: 1. To eliminate zonal nonuniformity of the structural constituents in casting of plain bearings the bearing shell temperature must be not less than 280°C and the cooling rate not more than 200°C/min. 2. To obtain a more favorable structure of the babbitt lining the use of brass or bronze is recommended as the material of the bearing shell. 3. To reduce zonal nonuniformity the temperature of the B83 babbitt case must not exceed 520°C. 4. The optimum cooling rate providing a fine-grained structure of the structure constituents of the babbit lining is 180-200°C/min, which is obtained by the use of air or airwater-cooling with a low water content. Plenum Publishing Corporation, 1991 Metal Science and Heat Treatment Kluwer Academic Publishers-Plenum Publishers 32/9(1990-09-01), 708-711 0026-0673 32:9<708 1990 32 11041 https://doi.org/10.1007/BF00693342 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/BF00693342 text/html Onlinezugriff via DOI NATIONALLICENCE 100 1- Gromyko A. aut NATIONALLICENCE 773 0- Metal Science and Heat Treatment Kluwer Academic Publishers-Plenum Publishers 32/9(1990-09-01), 708-711 0026-0673 32:9<708 1990 32 11041 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer