caa a22 4500 467982031 CHVBK 20180323112521.0 cr unu---uuuuu 170328e19900301xx s 000 0 eng 10.1007/BF00730916 doi (NATIONALLICENCE)springer-10.1007/BF00730916 Loshkarev V. aut A calculation investigation of the influence of stresses on the structure of steel parts being hardened [Elektronische Daten] [V. Loshkarev] Conclusions: 1. According to the data of a calculation analysis internal stresses may both accelerate and slow formation of pearlite and bainite in steel parts and, in particular, cause reverse hardening in quenching. 2. Stresses have a stronger influence on the degree of development of the pearlitic transformation in the axial zone of rotor-type parts than on the hardenability of the surface layer of rolling roll-type parts. 3. With a sufficiently high sensitivity of transformations in steel to stresses there is a cooling rate of parts in quenching, exceeding of which is undesirable, which is the optimum for suppression of the pearlitic transformation in the axial zone. 4. The structure of the axial zone of parts may be improved by the use of stepped hardening cycles with slowed cooling during the martensitic transformation in the surface zone of the metal. Plenum Publishing Corporation, 1990 Metal Science and Heat Treatment Kluwer Academic Publishers-Plenum Publishers 32/3(1990-03-01), 173-179 0026-0673 32:3<173 1990 32 11041 https://doi.org/10.1007/BF00730916 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/BF00730916 text/html Onlinezugriff via DOI NATIONALLICENCE 100 1- Loshkarev V. aut NATIONALLICENCE 773 0- Metal Science and Heat Treatment Kluwer Academic Publishers-Plenum Publishers 32/3(1990-03-01), 173-179 0026-0673 32:3<173 1990 32 11041 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer