caa a22 4500 46909026X CHVBK 20180323133015.0 cr unu---uuuuu 170328e19920501xx s 000 0 eng 10.1007/BF01141966 doi (NATIONALLICENCE)springer-10.1007/BF01141966 Khvan D. Voronezh Polytechnic Institute, USSR aut Plastic compression of long cylinders [Elektronische Daten] [D. Khvan] The possibility of implementing the method of plastic compression of long cylinders using supporting elements is substantiated. Relationships for calculating the limiting geometric parameters of compressible rods and the supporting pressure required to upset the specimens in a linear stress state are obtained. An example is cited for the calculation of the taper angle of the sectors used in the apparatus as supporting elements. The results of comparison of the compression and tension diagrams suggest sufficient accuracy of experimental data obtained using the indicated apparatus; this enables us to recommend it for investigation of the plastic properties of materials. Plenum Publishing Corporation, 1992 Strength of Materials Kluwer Academic Publishers-Plenum Publishers 24/5(1992-05-01), 366-371 0039-2316 24:5<366 1992 24 11223 https://doi.org/10.1007/BF01141966 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/BF01141966 text/html Onlinezugriff via DOI NATIONALLICENCE 100 1- Khvan D. Voronezh Polytechnic Institute, USSR aut NATIONALLICENCE 773 0- Strength of Materials Kluwer Academic Publishers-Plenum Publishers 24/5(1992-05-01), 366-371 0039-2316 24:5<366 1992 24 11223 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer