caa a22 4500 475798104 CHVBK 20180406123730.0 cr unu---uuuuu 170329e20000501xx s 000 0 eng 10.1007/s001700050171 doi (NATIONALLICENCE)springer-10.1007/s001700050171 Čuš F. Faculty of Mechanical Engineering, University of Maribor, Maribor, Slovenia, SI aut The Inclusion of the Geometrical Shape of the Cutter into the Optimisation of the Milling Process [Elektronische Daten] [F. Čuš] The paper deals with the optimisation model of cutting variables by which the manufacturing costs should be reduced to the lowest possible value. The optimisation strategy takes place in two steps by taking into account all input variables (technological limitations). First, the tool geometric variables are changed using selected cutting variables; in this way, the smallest cutting force variables are determined. Geometric variables for the case of the smallest cutting force are used for the second optimisation step in which the cutting variables are changed. Optimisation of the cutting variables is tested practically under workshop conditions. In this way, important information about the validity of the optimised values is obtained. If there are significant differences between the theoretical and practical values, then the theoretical values must be corrected (correction of cutting variables). As the study of the cutting processes requires much experimental and theoretical work and applies to a very large body of data, we have organised an information centre for cutting conditions. When forming the information centre for cutting conditions, it was impossible to avoid the requirement that the technological database must be actively included in the computer-supported integrated manufacture.: Springer-Verlag London Limited, 2000 Keywords:Cutter geometry nationallicence Cutting force nationallicence Milling nationallicence Optimisation nationallicence Technological data bank nationallicence https://doi.org/10.1007/s001700050171 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/s001700050171 text/html Onlinezugriff via DOI NATIONALLICENCE 100 1- Čuš F. Faculty of Mechanical Engineering, University of Maribor, Maribor, Slovenia, SI aut Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer