naa a22 4500 510790771 CHVBK 20180411083319.0 cr unu---uuuuu 180411e20130301xx s 000 0 eng 10.1007/s12289-011-1066-3 doi (NATIONALLICENCE)springer-10.1007/s12289-011-1066-3 Experimental investigation of a new hybrid molding process to manufacture high-performance composites [Elektronische Daten] [Marco Fiorotto, Giovanni Lucchetta] Reducing vehicle weight to reduce energy consumption and engine emissions is one of the major objectives of the automotive industry. The novel molding technology, presented in this paper, is suited to meet this demand. In this process, a thermoformed fiber-reinforced thermoplastic sheet is inserted into the mold and a long-fiber reinforced thermoplastic is injected to form a rib structure. Short cycle times make the technique an economic option for the manufacturing of hybrid high performance composites. This special integrative injection molding method optimizes efficiencies and thus energy consumption. A basic concept was realized to show the manufacture procedure. The mechanism of adhesion bonding between the long fiber thermoplastic material and the formed fabric and the influence of the main injection molding process parameters on the adhesion quality was experimentally investigated according to the Design of Experiments method. Then experimental tests were used to measure the structural properties of hybrid composites. Springer-Verlag France, 2011 In-mold forming nationallicence Hybrid process nationallicence Composite manufacturing nationallicence Sustainable vehicle nationallicence Fiorotto Marco Department of Innovation in Mechanics and Management, University of Padova, Via Venezia 1, 35131, Padova, Italy aut Lucchetta Giovanni Department of Innovation in Mechanics and Management, University of Padova, Via Venezia 1, 35131, Padova, Italy aut International Journal of Material Forming Springer-Verlag 6/1(2013-03-01), 179-185 1960-6206 6:1<179 2013 6 12289 https://doi.org/10.1007/s12289-011-1066-3 text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/s12289-011-1066-3 text/html Onlinezugriff via DOI NATIONALLICENCE 700 1- Fiorotto Marco Department of Innovation in Mechanics and Management, University of Padova, Via Venezia 1, 35131, Padova, Italy aut NATIONALLICENCE 700 1- Lucchetta Giovanni Department of Innovation in Mechanics and Management, University of Padova, Via Venezia 1, 35131, Padova, Italy aut NATIONALLICENCE 773 0- International Journal of Material Forming Springer-Verlag 6/1(2013-03-01), 179-185 1960-6206 6:1<179 2013 6 12289 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer