naa a22 4500 510822339 CHVBK 20180411083539.0 cr unu---uuuuu 180411e20130601xx s 000 0 eng 10.1007/s12541-013-0122-y doi (NATIONALLICENCE)springer-10.1007/s12541-013-0122-y Power consumption and tool wear assessment when machining titanium alloys [Elektronische Daten] [Salman Pervaiz, Ibrahim Deiab, Basil Darras] Titanium alloys are of interest for aerospace industries due to their high strength to weight ratio, outstanding corrosion and erosion properties and ability to operate at higher temperature. They are classified as difficult to cut materials because of their low thermal conductivity, high chemical reactivity and high strength at elevated temperature. The machinability rating of titanium alloys is low compared to other materials from many aspects. This study focuses on studying the cutting tool wear and power consumption when machining Titanium alloys under different cutting conditions. Design of experiments was used to develop a test matrix that cover the range of cutting conditions recommended for machining titanium alloys. Cutting forces, power consumption, tool wear and surface roughness were measured and analyzed. Tool wear mechanisms were also studied using scanning electron microscopy. Korean Society for Precision Engineering and Springer-Verlag Berlin Heidelberg, 2013 Machinability nationallicence Wear mechanisms nationallicence Energy consumption nationallicence Titanium nationallicence Pervaiz Salman Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut Deiab Ibrahim Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut Darras Basil Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut International Journal of Precision Engineering and Manufacturing Korean Society for Precision Engineering 14/6(2013-06-01), 925-936 2234-7593 14:6<925 2013 14 12541 https://doi.org/10.1007/s12541-013-0122-y text/html Onlinezugriff via DOI 1 research-article jats NATIONALLICENCE 856 40 https://doi.org/10.1007/s12541-013-0122-y text/html Onlinezugriff via DOI NATIONALLICENCE 700 1- Pervaiz Salman Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut NATIONALLICENCE 700 1- Deiab Ibrahim Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut NATIONALLICENCE 700 1- Darras Basil Department of Mechanical Engineering, College of Engineering, American University of Sharjah, 26666, Sharjah, United Arab Emirates aut NATIONALLICENCE 773 0- International Journal of Precision Engineering and Manufacturing Korean Society for Precision Engineering 14/6(2013-06-01), 925-936 2234-7593 14:6<925 2013 14 12541 Metadata rights reserved Springer special CC-BY-NC licence nationallicence BK010053 XK010053 XK010000 NATIONALLICENCE NATIONALLICENCE NL-springer