Acetate is a superior substrate for microbial fuel cell initiation preceding bioethanol effluent utilization
| LEADER | caa a22 4500 | ||
|---|---|---|---|
| 001 | 605506205 | ||
| 003 | CHVBK | ||
| 005 | 20210128100625.0 | ||
| 007 | cr unu---uuuuu | ||
| 008 | 210128e20150601xx s 000 0 eng | ||
| 024 | 7 | 0 | |a 10.1007/s00253-015-6513-5 |2 doi |
| 035 | |a (NATIONALLICENCE)springer-10.1007/s00253-015-6513-5 | ||
| 245 | 0 | 0 | |a Acetate is a superior substrate for microbial fuel cell initiation preceding bioethanol effluent utilization |h [Elektronische Daten] |c [Guotao Sun, Anders Thygesen, Anne Meyer] |
| 520 | 3 | |a This study assessed cell voltage development, electricity recovery, and microbial community composition in response to initial substrate including acetate, xylose, acetate/xylose 1:1 mixture (ace/xyl), and bioethanol effluent (BE) during microbial fuel cell (MFC) operation at 1000 Ω external resistance. The BE mainly contained 20.5g/L xylose, 1.8g/L arabinose, and 2.5g/L propionic acid. The MFCs initially fed with acetate showed shorter initiation time (1day), higher average cell voltage (634 ± 9mV), and higher coulombic efficiency (31.5 ± 0.5%) than those initially fed with ace/xyl or xylose. However, BE-initiated MFCs only generated 162 ± 1mV. The acetate-initiated MFCs exhibited longer adaptation time (21h) and lower cell voltage (645 ± 10mV) when the substrate was switched to xylose, whereas substrate switching to BE produced the highest voltage (656mV), maximum power density (362 ± 27mW/m2), maximum current density (709 ± 27mA/m2), and coulombic efficiency (25 ± 0.5%) in the acetate-initiated MFCs. The microbial community in acetate-initiated MFCs was less diverse and contained more electrogenic bacteria (13.9 ± 0.4%) including Geobacter sulfurreducens and Desulfuromonas acetexigen than the MFCs initially fed with ace/xyl, xylose, and BE. After switching the substrate to xylose and subsequently to BE, the microbial community in the acetate-initiated MFCs became more diverse, while no significant changes were observed in ace/xyl-, xylose-, and BE-initiated MFCs. The results showed that initial substrate affected the power generation and the capability to adapt to the substrate alteration in MFCs. Acetate-initiated MFCs showed best performance in utilizing BE. | |
| 540 | |a Springer-Verlag Berlin Heidelberg, 2015 | ||
| 690 | 7 | |a Microbial fuel cell |2 nationallicence | |
| 690 | 7 | |a Bioethanol effluent |2 nationallicence | |
| 690 | 7 | |a Denaturing gradient gel electrophoresis |2 nationallicence | |
| 690 | 7 | |a Biofilm |2 nationallicence | |
| 690 | 7 | |a Coulombic efficiency |2 nationallicence | |
| 700 | 1 | |a Sun |D Guotao |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | |
| 700 | 1 | |a Thygesen |D Anders |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | |
| 700 | 1 | |a Meyer |D Anne |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | |
| 773 | 0 | |t Applied Microbiology and Biotechnology |d Springer Berlin Heidelberg |g 99/11(2015-06-01), 4905-4915 |x 0175-7598 |q 99:11<4905 |1 2015 |2 99 |o 253 | |
| 856 | 4 | 0 | |u https://doi.org/10.1007/s00253-015-6513-5 |q text/html |z Onlinezugriff via DOI |
| 898 | |a BK010053 |b XK010053 |c XK010000 | ||
| 900 | 7 | |a Metadata rights reserved |b Springer special CC-BY-NC licence |2 nationallicence | |
| 908 | |D 1 |a research-article |2 jats | ||
| 949 | |B NATIONALLICENCE |F NATIONALLICENCE |b NL-springer | ||
| 950 | |B NATIONALLICENCE |P 856 |E 40 |u https://doi.org/10.1007/s00253-015-6513-5 |q text/html |z Onlinezugriff via DOI | ||
| 950 | |B NATIONALLICENCE |P 700 |E 1- |a Sun |D Guotao |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | ||
| 950 | |B NATIONALLICENCE |P 700 |E 1- |a Thygesen |D Anders |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | ||
| 950 | |B NATIONALLICENCE |P 700 |E 1- |a Meyer |D Anne |u Center for BioProcess Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Building 229, DK-2800, Kgs. Lyngby, Denmark |4 aut | ||
| 950 | |B NATIONALLICENCE |P 773 |E 0- |t Applied Microbiology and Biotechnology |d Springer Berlin Heidelberg |g 99/11(2015-06-01), 4905-4915 |x 0175-7598 |q 99:11<4905 |1 2015 |2 99 |o 253 | ||